Description
A 100mm elbow at 45 degrees is often all you need to move a flue past a ceiling joist, a beam or a roof truss. This stainless steel elbow joins straight 100mm pipe on both ends and changes direction at a gentle angle, so smoke keeps flowing and soot has fewer places to build up.
100mm Elbow 45 Degree Bend Details
- Diameter: 100mm
- Angle: 45 degree bend
- Material: stainless steel
- Weight: 0.2 kg
- Type: non-insulated (single skin)
Where it is used
The 100mm bend suits small appliances and smaller flue systems. Two 45 degree bends can create an offset, which is a common way to step a flue sideways. A 45 degree bend is kinder to the draw than a sharp 90 degree turn. Browse the full 45 degree elbow range or all flue elbows for other sizes.
Fitting note
Keep the number of bends to a minimum and leave enough straight run above them for a good draw. Our flue installation team can plan the route and fit it safely.
Can I use a 100mm 45 degree bend in place of a 90?
Often yes, and it usually draws better. Two 45s give a smoother offset than one 90. We can check your layout before you buy.
Planning a flue route? Ask our team for parts and fitting advice.
