Description
The 230mm Elbow 45 lets you change the direction of a 230mm flue by 45 degrees without choking the smoke path. It is the part installers reach for when a straight run would hit a roof truss, a beam or the edge of a ceiling board. Two of these together give a neat offset so the flue can step sideways and then carry on straight up.
230mm Elbow 45 Degree Bend Features
- Stainless steel elbow: handles flue heat and does not rust in winter rain or coastal air.
- Soft 45 degree bend: a gentler angle than a 90 degree elbow, so smoke flows freely and soot builds up less.
- Non-insulated design: made for standard single wall runs inside the room.
- Light to handle: it weighs 0.72 kg, which keeps the joints easy to support.
Which fireplaces does it suit?
It fits flue systems built on 230mm pipe, which is common on larger wood fireplaces, open fire inserts and some braai hoods. Check that your appliance outlet matches before ordering. Browse other angles in our flue elbows range, or see all flues and accessories.
Fitting note
Building codes limit how many bends a flue may have, and every bend reduces draw a little. Our team plans the route first and fits each joint with the right overlap and support during a flue installation in Cape Town.
Is a 45 degree bend better than a 90 degree one?
For wood fires, usually yes. Smoke and soot pass a 45 degree bend more easily, the flue is simpler to sweep, and draw stays stronger. A 90 degree elbow is mainly used where a rear outlet has to turn straight up.
Planning a flue route with an offset? Send us your measurements and we will list every part you need.
